ABOUT OUR PAINT & COATINGS SERVICES
NACE-certified coating and surface protection for structures, tanks, and equipment. Specializing in sandblasting and brush, roll and spray applications.
Corrosion doesn't announce itself
A tank, a structural member, or a pipeline can be losing thickness under a failing coating for years before it shows — by then you're looking at replacement, not recoating.
Bad prep means paying for it twice
Coating over rust, moisture, or old paint that wasn't properly removed looks fine at hand-off and fails within a season — and the second job costs more than the first would have.
A failed floor coating is a compliance problem
Epoxy floors and containment areas exist to stop a spill from becoming an environmental incident. A coating that fails there isn't cosmetic — it's a liability.
What our Paint & Coating Team Handles.
Industrial paint & coating removal
Removing failed or existing coatings down to bare substrate, ready for recoating.
Pressure washing service
High-pressure washing to clean surfaces, remove contaminants, and prep for coating or inspection.
Structural applications
Coatings for structural steel and other load-bearing elements exposed to corrosion.
Tank & vessel interior/exterior
Interior and exterior coatings for storage tanks and process vessels.
Epoxy floors
Durable epoxy flooring for process areas, walkways, and high-traffic industrial floors.
Containment areas
Chemical-resistant coatings for secondary containment, keeping a spill from becoming an environmental incident.
General painting service
Brush, roll, and spray application offered for general facility and equipment painting.
SOUTHERN INDUSTRIAL SERVICE
A single-source mechanical contractor built for industrial facilities.
SAFETY-FIRST CREWS
Every job runs under the same safety discipline, whether it's a routine install or an emergency callout.
ONE CONTRACTOR, EVERY DISCIPLINE
Mechanical work coordinates directly with our electrical, civil, and instrumentation crews — no gaps between contractors to manage.
BUILT FOR URGENCY
Corrective and emergency repair crews are staffed to respond fast when a failure can't wait for a scheduled visit.
Whether it's a scheduled recoat or a surface that's failing sooner than expected, the process is the same three steps.
Getting industrial mechanical work done, without the back-and-forth.
TELL US WHAT'S GOING ON
Call or request a quote with the surface, the substrate condition, and the timeline — especially if it needs to happen inside a shutdown window.
WE SCOPE IT ON-SITE
Our team inspects the existing coating and substrate, confirms the spec, and gives you a clear plan and schedule before any prep work starts.
OUR CREWS EXECUTE
Removal, prep, and coating — done to NACE standard, on schedule, so the protection holds up rather than needing a second pass.
